Jump to content
  • 0

Position initiale Zenmuse H3-2D?


David PATE

Question

Bonjour, 

Débutant dans le domaine, je me tourne vers le forum pour avoir des informations concernant la zenmuse.
Alors voila ce qu'il m'arrive, je possède un phantom 1 sur lequel j'ai installé une zenmuse H3-2D.
Jusqu'ici, tout c'est très bien passé, montage facile et premiers essais relativement concluant. 
Relativement car je souhaiterais savoir s'il est possible de modifier l'angle initial de la caméra (lorsque que tout est branché, prêt à voler).
Je trouve l'angle un peu bas (même en bougeant le tilt à fond).
J'ai essayé de trouver des informations sur le site DJI pour savoir s'il est possible de modifier ça mais ce n'est pas vraiment clair. 
Pour information je possède un mac et je ne sais pas s'il est possible d'y installer le logiciel assistant.
Merci par avance de votre aide.

Link to comment
Share on other sites

Recommended Posts

  • 0

Bon maintenant que la nacelle est calibré, un nouveau problème se pose...

J'ai voulu faire un essai en vol mais le phantom ne démarre pas...

Voici le message d'erreur... Pour moi c'est du chinoi.

 

"

Motors Start failure caused by TX stick(s) mid point error too big

If the TX stick(s) mid point error is too big, Motors Start will fail when you execute the Combination Stick Commands (CSC) and lead to the aircraft will not takeoff.. And the LED will blink Red four times per second continually to warn you.

TX stick(s) mid point error too big can be caused by the following reasons:

(1) There is TX stick (except the throttle stick) not at center when power on the autopilot system.

(2) The TX sticks has been trimmed, which leads to the large deviation of mid point. For example, the SUB-TRIM has been adjusted for Futaba transmitter.

(3) The TX stick(s) travel has larger asymmetry.

For the reason (1), please put all TX sticks at the mid point, and then power cycle the autopilot system to re-record the mid point. If the problem continues, that can be caused by the reason (2) or reason (3), you need to adjust the output range of your TX, and then use the Assistant Software to redo the TX calibration. Please carry out the following procedures.

(1) Connect to the Assistant software, click Basic-> R/C-> Command Sticks Calibration, and push all TX sticks throughout their complete travel range to see if any stick cannot reach its largest position.

(2) Adjust the largest travel of TX stick until the cursor on the Assistant software can reach both end positions, according to your TX manual.

(3) Power cycle the autopilot system, note that power cycle is required.

(4) Redo the TX calibration according to the Assistant software."

 

 

Est ce qur je peux encore te solliciter?

Merci

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  •  

×
×
  • Create New...