Le problème est que dans l'assistant du naza m v2, sous Windows 10, je ne vois pas les sticks bouger. Pourtant, le bind se fait et le test des moteurs fonctionne.
Dans l'assistant le message d'erreur "Configuration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration. Re-calibrate your transmitter,and power cycle your controller and check all of the parameters." s'affiche et je n'ai pas trouvé comment le régler.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Johan chtrugzug
Bonjour,
J'ai un monté un DJI f450,
- naza m v2
- récepteur : graupner GR-16
- radiocontrolleur : graupner MX-16
Le problème est que dans l'assistant du naza m v2, sous Windows 10, je ne vois pas les sticks bouger. Pourtant, le bind se fait et le test des moteurs fonctionne.
Dans l'assistant le message d'erreur "Configuration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration. Re-calibrate your transmitter,and power cycle your controller and check all of the parameters." s'affiche et je n'ai pas trouvé comment le régler.
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.